$49 with free shipping 

LightGuards

Installation

No holes to drill

LightGuards are installed with the same nut that is holding your light fixture in place.

No need to disconnect wiring

The LightGuards are installed without disconnecting the wiring.


Step 1

Remove the mounting nut from the light stud and lift the light fixture above the fender.

Step 2

Position the LightGuard to line up with the wire for the light.

Slide the LightGuard past the wire.

Step 3

Slide the LightGuard to align with the fender hole to allow the stud of the light fixture to drop through both the LightGuard and the fender.

Replace and tighten the mounting nut.